When you want to install epoxy flooring in your garage, the first thing you have to do is prepare the floor properly. If your garage floor has a lot of Efflorescence, you will want to abrade the concrete floor before applying the epoxy. Then you need to check the humidity levels to determine the drying time. This article will go over the factors that affect the drying time. Once you know what factors affect the time of epoxy flooring installation, you can proceed with the installation.

Efflorescence on garage floor

If your new garage flooring is showing signs of efflorescence, it could be a sign of moisture issues. After cleaning, you might notice a white powdery residue on a spot. Efflorescence occurs when moisture penetrates the concrete and causes it to turn white. A few reasons could be leaky pipes or poor drainage. Regardless of the cause, it’s important to determine the cause of the efflorescence before applying the new epoxy coating.

Abrade concrete floor before applying epoxy

The process of preparing a concrete floor before applying an epoxy coating is a crucial step in installing a beautiful, durable, and long-lasting flooring finish. Most coatings professionals recommend abrading the floor with a special solution to open up the concrete pores and create a rougher surface for the epoxy to adhere to. The solution is often purchased in a kit and requires dilution with water before being applied to the concrete. The solution will foam and fizz on the surface of the concrete and cause the floor to become rougher.

Drying time of epoxy flooring

Typically, the cure time of epoxy flooring is about seven days at 65degF/20degC. However, some types of epoxy flooring will cure quicker than others. While most epoxies reach full chemical cure in around seven days, polyaspartic flooring requires a much longer period of time before it is ready for heavy traffic. It is best to allow seven days to allow your epoxy to fully cure before driving your car on it. Continue reading about Vancouver epoxy experts

Humidity

When applying an epoxy floor, you should keep in mind the temperature of your area. The floor should be around 55 degrees Fahrenheit. If the temperature is much lower, the resin may not bond as well or may take a longer time to cure. A propane heater will also help to raise the ambient temperature. Humidity should be kept below 77 degrees Fahrenheit for epoxy flooring to bond properly.

Etching process

Etching a concrete floor is a great way to make your floor look brand new. This process is done by applying a chemical solution to the concrete floor. The solution should foam immediately upon application, so make sure you stay on it until the foam stops. The etching solution may be stronger than the recommended 3:1 ratio, so follow the directions on the label. Do not remove the acid solution until the reaction has finished. After this step, your concrete floor will look brand new and will resist any wear and tear that comes with regular use.